Silicone Handle Stock or Bottle Stopper Casting Mold - 2" x 2" x 6"

Casting custom handle stock and bottle stopper blanks from epoxy and polyester resins is a whole lot easier now with the WoodRiver® Silicone Handle Stock/Bottle Stopper Casting Mold. This reusable casting mold has been designed with 3 mm fillets in all corners to aid in the mold’s release, as well as pre-rounded corners for easier turning, with the exception of the top four edges. Mold release agents will make removing the blank from the mold easier and will help extend the life of the mold.

To create bottle stopper blanks, use WoodRiver Silicone Flat Dams (#174216, sold separately) to divide the mold in half so you may pour two completely different blanks in the same cavity. Due to the size of the mold, it may be necessary to apply light pressure against the dam, using tape or a small clamp, to ensure a tight seal at the top of the mold.

Features:

• Cast one or two bottle stopper blanks
• Cast amazing 2" x 2" x 6" handle stock material
• Reusable silicone mold
• 3 mm fillets incorporated into the mold to aid in release
• Rounded corners make the blank easier to turn
• Mold release aids in releasing the blank and also extends overall life
• Clean with denatured alcohol as needed

Specifications:

• Material: silicone
• Project: casting handle or bottle stopper blanks

What's Included:

• (1) Silicone Handle Stock or Bottle Stopper Casting Mold - 2" x 2" x 6"

Notes:
Maintenance is important for this reusable bottle stopper or handle stock mold; we recommend using denatured alcohol to clean it.